Windsor Zephyr Bedienungsanleitung Seite 9

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 33
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 8
English 9
The safety cap must not be attached to
the boiler while descaling is being
carried out. Make sure that the cleaner
can not be used while there is any
descaling solution left in the boiler.
Pour the contents of the boiler out at the side (see
illus.), and rinse out the boiler at least twice with
cold water to ensure that no descaling solution or
deposits are left inside.
Switch on the cleaner.
Press the reset button until the “Descaling due”
light extinguishes.
Your steam cleaner is now ready for use again.
After approx. 50 operating hours, the “Descaling
due” light will illuminate to show that it is time to
descale the appliance once more.
Note: If you use distilled water exclusively, it will
not be necessary to descale the cleaner.
When the “Descaling due” indicator light illumina-
tes, just press the reset button until the light goes
out.
Filter replacement
When using polluted water the filter can become
blocked. This makes itself apparent either by
extraordinarily long running times of the pump or
a total functional failure. In this case the filter
should be replaced.
3.2 What to do if there is a problem
If the low-water warning lamp lights up because
the unit has been stood upright although it still
operating, follow the procedure described in the
section “Refilling the boiler with water”.
If you encounter any other problems with the
cleaner, you should contact your local authorized
customer service agent.
3. Care, Maintenance & Troubleshooting
3.1 Cleaning the boiler
Rinsing out the boiler
To clean the boiler, we recommend that you fill it
with water and shake it vigorously. This should
loosen any scale that has settled at the bottom of
the boiler. If you now pour the water out of the
boiler, the scale will be flushed out at the same
time (see illus.).
For soft water (up to 1.8 mmol/L) the boiler should
be flushed out after it has been refilled 15 times,
for harder water after every fifth time.
Descaling the boiler
We recommend that you descale the appliance as
soon as the “Descaling due” indicator light
illuminates.
In order to remove any scale that has built up on
the walls of the boiler, we recommend that you
clean the boiler with Decalcifying Liquid.
In order to avoid damaging your steam cleaner,
use only products for descaling that have been
officially approved by WINDSOR.
Procedure:
Unplug the steam cleaner from the electrical
outlet.
Empty the boiler entirely of any remaining water.
Dissolve the contents of two bags in 0.5 gal (2
litre) of warm water while continuously stirring the
liquid at the same time.
Pour the solution into the boiler, and allow to stand
for approx. 8 hours.
Seitenansicht 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 32 33

Kommentare zu diesen Handbüchern

Keine Kommentare