Windsor COMDUX Betriebsanleitung PDF herunterladen (Seite 32)

Maintenance

Scrub Head

The dual cylindrical scrub head is designed to scrub

chemical into the carpet. The two counter rotating

brushes raise the pile of the carpet, giving it a lush

groomed appearance.

Maintenance

Scrub brushes should be exchanged front to back

every 50 hours to ensure even wear. Scrub brushes

should be replaced as a set when bristle length wears

to height of yellow PerformAlert

bristles

Scrub Brushes

Scrub Brush Removal

The scrub brushes are removed from the right side of

the machine.

1. Raise the scrub deck to the storage position.

2. Pull out on the bottom of the retaining clip.

3. The brush assembly and end cap should drop

down. Then pull the brush down far enough to

clear the bottom of the housing.

4. Pull brush out with a rocking motion to free brush

from drive hub.

Bearing Cleaning

1. Remove bearing cap from end of brush.

2. Clean cap and bearings.

Scrub Brush Replacement

1. Lift the drive side of the brush and push it onto

drive hub until a positive stop is felt. The brush

cannot be installed until the brush is fully seated on

the drive hub.

2. Pull out on the bottom of the retaining clip.

3. Line up the end cap with the flats to each side.

4. Slide brush up into the retaining clip until it clicks in

place.

86400200 Operators Manual - Commodore Duo

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 48 49

Keine Kommentare

Windsor COMDUX Betriebsanleitung Seite 32