Windsor CSCM26SP Betriebsanleitung PDF herunterladen (Seite 38)

Maintenance

Replacing or Installing Scrub Brushes -

Disk

FOR SAFETY: Before leaving or servicing the

machine; stop on level surface, turn OFF machine

and remove key.

1. Turn machine power off.

2. Open access cover on deck shroud.

3. Locate release lever, press release lever towards

front of machine to release brush pad. The pad will

drop down when released. Lift deck shroud up and

slide brush/pad assembly out.

4. Remove brush/pad from holder and replace with

new brush/pad.

5. To reinstall, lift deck shroud upward as shown.

Center the brush/pad driver under the brush drive

hub. Raise brush/pad until it contacts brush driver

assembly. Turn clockwise until release lever plate

locks into position.

6. Check that release lever/plate is completely closed

and pad/brush is securely attached.

NOTE: Damage to driver or brush could occur if not

securely attached.

86367610 Chariot CS26

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 152 153

Keine Kommentare

Windsor CSCM26SP Betriebsanleitung Seite 38