Windsor SCX364 Betriebsanleitung PDF herunterladen (Seite 30)

100

101

Maintenance

Actuator Scrub Deck Up-Down Removal/

Replacement

FOR SAFETY: Before leaving or servicing

machine, stop on a level surface, turn off

machine and set parking brake (If option is

installed).

1. Remove front cover.

2. Remove clevis pin and rue ring from lower bracket

of actuator; do not allow actuator barrel to rotate.

3. Disconnect actuator from wiring harness.

4. Remove upper clevis pin and rue ring from

actuator bracket.

5. Reverse steps to install.

Scrub Deck Up-Down Actuator Adjustment

The actuator will need to be adjusted when replaced.

To adjust the actuator:

1. While holding actuator barrel to prevent it from

spinning, apply power to the actuator such that it is

fully extended. Positive power to white wire, and

negative/ground to black. Limit switch within

actuator will stop it.

2. Turn barrel out one or more full turns to assure that

when it is retracted it will not bind against itself.

3. While holding actuator barrel to prevent it from

spinning, apply power to the actuator such that it is

fully retracted. Positive power to black wire, and

negative/ground to white wire. Limit switch within

actuator will stop it.

4. With actuator fully retracted, turn barrel in until it

touches the base of the threaded shaft.

5. At the bottomed out position, turn the barrel out 1

1/2 turns, then enough more to allow connection to

lift linkage.

6. Connect actuator to lift linkage.

7. Check travel of actuator during operation.

Actuator Scrub Deck In-Out Removal/

Replacement

FOR SAFETY: Before leaving or servicing

machine, stop on a level surface, turn off

machine and set parking brake (If option is

installed).

1. Remove front cover.

2. Swing the deck to the fully open position. This will

align the access holes in the deck plates so that

the clevis pin can be removed.

3. Remove the clevis pin and rue ring from both ends

of the actuator.

4. Disconnect actuator from wiring harness.

5. Reverse steps to install.

Scrub Deck In-Out Actuator Adjustment

The actuator will need to be adjusted when replaced.

To adjust the actuator:

1. While holding actuator barrel to prevent it from

spinning, apply power to the actuator such that it is

fully extended. Positive power to white wire, and

negative/ground to black. Limit switch within

actuator will stop it.

2. Turn barrel out one or more full turns to assure that

when it is retracted it will not bind against itself.

3. While holding actuator barrel to prevent it from

spinning, apply power to the actuator such that it is

fully retracted. Positive power to black wire, and

negative/ground to white wire. Limit switch within

actuator will stop it.

4. With actuator fully retracted, turn barrel in until it

touches the base of the threaded shaft.

5. At the bottomed out position, turn the barrel out 1/2

of a turn, then enough more to allow connection to

linkage.

6. Connect actuator to linkage.

7. Check travel of actuator during operation.

86037150 SCX364

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 100 101

Kommentare zu diesen Handbüchern

Keine Kommentare

Windsor SCX364 Betriebsanleitung Seite 30

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Scrubber Windsor SCX364