Windsor SCEX324 Betriebsanleitung Seite 16

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 100
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 15
MACHINE OPERATION
CUTTER 24V (SCE) 86037020 04/04/07
PRE-RUN MACHINE INSPECTION
Do a pre-run inspection to find possible problems that
could cause poor performance or lost time from
breakdown. Follow the same procedure each time to
avoid missing steps.
NOTE: See maintenance section for pre-run machine
inspection checklist items.
STARTING MACHINE
NOTE: Perform pre-run machine check before operating
machine.
FOR SAFETY: Before starting machine, make sure
that all safety devices are in place and operating
properly.
1. Turn the machine power on.
2. Release the parking brake, if your machine is
equipped with this option.
3. Engage the direction propel levers for the desired
direction.
EMERGENCY STOP PROCEDURES
1. Release the propel levers.
2. Turn machine power off with key switch.
3. If an electrical problem is suspected push in
emergency stop button, if machine is equipped with
this option.
3-9
4. Apply brakes, if your machine is equipped with this
option.
FILLING SOLUTION TANK
FOR SAFETY: Before leaving or servicing machine;
stop on level surface, turn off machine and remove
key.
1. Turn the machine power off.
2. Set the parking brake if your machine is equipped
with this option.
3. Remove solution tank cover.
4. Fill the solution tank with clean water, leaving
enough room for the required amount of cleaning
solution. The solution tank capacity filled to 2” (5 cm)
from bottom of fill inlet is 23 gallons (87 liters). The
water must not be hotter than 140° F (60°C) to
prevent damage to the tank.
5. Measure the chemical into the solution tank. Liquid
chemicals should be added to the solution tank after
filling with water. Dry chemicals should be
thoroughly mixed before being added into solution
tank. Commercially available, high alkaline floor
cleaners, are suitable for use in the solution system.
NOTE: Read the chemical manufacturers recommended
proportion instructions.
6. Replace solution tank cover.
! WARNING
Flammable materials can cause an explosion or fire.
Do not use flammable materials in the tanks.
Seitenansicht 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 99 100

Kommentare zu diesen Handbüchern

Keine Kommentare